The layer is the part of the "p" that disappeared. 2 nozzle but I've flipped the model 180 into the orientation that Migael shows ("h" is up). That gap makes it look like Cura is not acknowledging that it is part of the body of the model(?) or there is a tiny gap between the model and the letter. This is an ortho view of the "c" in plastic. Take another look at the model though as there may be something going on there. Make sure to include a 3mf file when you fill out the form for the bug report. Yes, GitHub is the proper place for a bug report. When rotated CW different letters disappear and other come back. CCW as you had it is missing some letters. Horizontal is OK, Vertical is a mess.ĮDIT: The differences occur due to the model rotation. The end "cs" was there and now it's gone and the entire "h" is back. I have rotated and sliced the model a couple of times and now different letters are missing. Out of curiosity - did you paste the lettering onto the surface or did you bury them in the main model and just let a bit protrude? The missing letters are missing in their entirety rather than just portions being ignored. The "p" has been altered and instead of a radius it is cut straight across. I am in compatibility mode so I don't get the nice representation but it looks like the lower portion of the "h" is gone as well as the serifs on the left side of the upright of the "h". When the lettering is vertical it comes out like you show - partial "h", l's are missing, etc. With the words horizontal it sliced and everything was there. I used the tools in Cura but they didn't help. When I opened the file I received the "Model is not Watertight" warning. Steunschep versie.stl Edited Januby Migael I should report this to the github, right? So I preformed a clean install of Cura 4.8.0 on my computer and the issue still occurs. I also included the stl so feel free to check it out. Just to be sure I just checked the model again in 3D builder* and meshmixer. So Cura was most likely the cause of my issue. This produced model with the complete logo using the same stl. Since I really wanted the logo appear fully on the print I used prusaslicer. ![]() The next step was obviously trying to slice it again. It would not have been the first time that I missed some letters and have updated the model multiple times during the design process. However when I checked the STL the logo was completely there and it did not give me any warnings in Cura or in the windows viewer.Īfter that I reviewed the g-code in which the logo was missing. Something must have gone wrong with exporting to model to STL. I feel that is least I could for using this free that was also my first thought. I did use prusaslicer for this model, but I found it quite strange behaviour of the slicer and would like to understand what I did wrong. I have not tried adaptive layers but have tried slicing it with different nozzles sizes and layers height which did not alleviate the problem. The diameter of nozzle only dictates the smallest wall you be able to print, however with most printer will be step in order a tenth or hundredth mm and is mostly depends on the (micro)steps of steppermotor(driver) and the size of the pulley. Would the orientation matter? I would expect that the slicer in both scenarios would just slight alter the toolpath in the XY-plane order to form the logo.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |